To use the plug on appliances from other manufacturers too, that maybe need a higher throughput during testing, it may be needed to create an eight pin self-loopback plug. This is the simpliest version of a four pin self-loopback plug which is used to test interface rx/tx operations on FastEthernet (100mbit/sec) interfaces. In the case of the FortiGate HQIP test, it is already enough to connect the following conductor wires: ![]() It is necessary to have a RJ45 connector or an Ethernet cable with a RJ45 connector attached. ![]() It is very easy to create a self-loopback cable or connector plug by yourself. In comparison to normal 'loopback' links, where one NIC is connected with another NIC on the same appliance, the self-loopback does realize the loopback inside the same NIC. Those cables are often descibed as selfloop or interface test cables. Please restore factory reset or use port mode to perform the test WARNING: This test can only pass with factory configurations. ![]() Network Interface Loopback Test - Please connect ethernet cables: This request looks like the following CLI output: On FortiGate models, it is necessary to connect a self-loopback cable on some ports during the HQIP test. This article describes how to make a self-loopback cable to perform HQIP test.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |